Field-Programmable Gate Arrays

15255 Threads Posts
to

FPGA Board with RF Front end

Has anyone come across an FPGA board with RF Front end at 2.4 GHz? or any 2 development kit (FPGA and RF Front end kit),...
4 comments posted 21yrs
posted by niravbsh
4 comments posted 21yrs posted by niravbsh

Quartus II Command Line and Project Files

Hi, I have a Verilog project created through the Quartus II 4.1 GUI under Windows. I am trying to build it (analyze, sy...
4 comments posted 21yrs
posted by vladan2005
4 comments posted 21yrs posted by vladan2005

Creating a pyramid of shift registers

Hi all, My problem is more of a VHDL problem but... I need to create the following pyramid alike design. in my declarat...
9 comments posted 21yrs
posted by moti
9 comments posted 21yrs posted by moti

Forward-Annotating constraints to Quartus

Hi, I have a problem with Forward-Annotating multicycle, false path constraints from Synplify Pro 7.7.1 to Quartus 4.2...
3 comments posted 21yrs
posted by bala2k4
3 comments posted 21yrs posted by bala2k4

USB Host

Anyone know of a device that makes implementing USB Host mode as painless as something like the FTDI chips? I need to h...
8 comments posted 21yrs
posted by 0_0_0_0_
8 comments posted 21yrs posted by 0_0_0_0_

Problems in timing simulations (clarifications)

Yes I have synthesized and placed and routed two times one time at 50 MHz and on time at 80 MHz. At each time, the .ucf...
0 comments posted 21yrs
posted by leconte.michel
0 comments posted 21yrs posted by leconte.michel

asynchronous logic on Actel Axcelerator?

Has anybody heard of or done an asynchronous design (delay-intolerant, isochronic fork, or logical-effort based) on Act...
0 comments posted 21yrs
posted by megacz
0 comments posted 21yrs posted by megacz

xilinx sdram controller (xapp134)

Hi I want to use xilinx sdram controller design (xapp134)to interface to my sdrams. After reading their application not...
0 comments posted 21yrs
posted by htj
0 comments posted 21yrs posted by htj

Problems in timing simulations

Hi all, I work with ISE.6.3.3i and ModelSim 5.8c the target is a Virtex II Pro 70 -6. My design has been P&R for two fr...
6 comments posted 21yrs
posted by leconte.michel
6 comments posted 21yrs posted by leconte.michel

HardCopy cost

Does anyone know what the basic costs are of doing an Altera HardCopy cycle? If, say I had a Stratix EP1S40 design that...
6 comments posted 21yrs
posted by rogerwilson
6 comments posted 21yrs posted by rogerwilson

Virtex-II start up

Hi all, What is good practise when resetting Virtex-II ? What I have done is to use the startup_virtex2 block. With the...
0 comments posted 21yrs
posted by nobbe
0 comments posted 21yrs posted by nobbe

What is the difference between ASIC and FPGA?.

Hello, I have two questions about Electronic circuit board design. These are the questions: 1st question: What is the m...
10 comments posted 21yrs
posted by tvnaidu
10 comments posted 21yrs posted by tvnaidu