Eagle - Layout an Schematic anpassen

Hallo,

ich habe hier ein Eagle-Schematic und das dazugehörige Layout offen. Nun habe ich im Schaltplan was geändert und das Layout ist nun nicht mehr konsistent. Wie sag ich Eagle nun, dass er mir die geänderten Bauteile und Leitungen im Layout anpassen soll?

Danke,

Thomas

Reply to
Thomas Finke
Loading thread data ...

Dann hattest du wohl beim Editieren das Board nicht offen.

Am Einfachsten: betreffende Bauteile löschen und neu einfügen.

Gruß, Johannes

Reply to
Johannes Bauer

Hallo Thomas,

ERC aufrufen, in der Ergebnidatei steht drin, was alles unterschiedlich ist.

Andersrum: Eagle sagt Dir, was Du von Hand alles aendern musst, damit BRD und SCH wieder konsistent sind.

Gruesse Hartmut

Reply to
Hartmut Schaefer

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.