Field-Programmable Gate Arrays

15255 Threads Posts
to

simprim errors

I generate a testbench and then do Simulate Post-Translate VHDL Model in ISE 6.2.03i. Modelsim frowns as follow: # ** E...
5 comments posted 22yrs
posted by yaseenzaidi
5 comments posted 22yrs posted by yaseenzaidi

spartan 3 on 4 layers

Hi guys I have just finished routing a simple board with a 208 pin qfp spartan 3. I have just used top and bottom layer...
41 comments posted 22yrs
posted by colin_toogood
41 comments posted 22yrs posted by colin_toogood

HDL-Models of CLB/Slice

Hallo. Where to find HDL-models of CLBs, so one could instantiate them directly (or just to get a basic idea of what's...
3 comments posted 22yrs
posted by post
3 comments posted 22yrs posted by post

Interfacing from the analogue domain

OK, I have a board with an XC2S150 on it, and a load of I/O pins; the wiring on the board and the configuration of the...
5 comments posted 22yrs
posted by twomack
5 comments posted 22yrs posted by twomack

level converter for high frequencies

Hi ng, i'm currently building a serial controller between a 5V FPGA and a 3.3V microcontroller. Maybe someone of you ca...
3 comments posted 22yrs
posted by stefan-oedenkoven
3 comments posted 22yrs posted by stefan-oedenkoven

EP1C12 or XC3S400?

Hi, I've seen this prototype board from Altium that seems to have a very good price: http://www.altium.com/livedesign/...
30 comments posted 22yrs
posted by arash.salarian
30 comments posted 22yrs posted by arash.salarian

Initializing Block Ram of a partial Bitstream

Hello, Does anybody know how to initialize a BlockRam of a PARTIAL BITSTREAM with an elf file? Arun
0 comments posted 22yrs
posted by iarunkumar
0 comments posted 22yrs posted by iarunkumar

xilinx VP20 and SDRAM

Hi! I have a XilinxVP20 chip with 2 PPC cores and a 32M SDRAM. what I want to do is to use the SDRAM as instruction mem...
0 comments posted 22yrs
posted by qudhs
0 comments posted 22yrs posted by qudhs

direct calculation of the modulus ?

Hi, Is there method that is more efficient than regular division for calculating modulus ? Thanks in advance. Mete
9 comments posted 22yrs
posted by mete
9 comments posted 22yrs posted by mete

Reading RAM while

This may sound trivial but why is data being output (read) on the out port during the write cycle in the Xilinx inferre...
3 comments posted 22yrs
posted by yaseenzaidi
3 comments posted 22yrs posted by yaseenzaidi

DCM for generating higher frequencies.

Hi all, Given a clock of 20Mhz can I generate 320Mhz clock output using single DCM in Xilinx FPGA? Regards Raghavendra.S...
3 comments posted 22yrs
posted by raghurash
3 comments posted 22yrs posted by raghurash

newbie question

hello there, i m a newbie to this fpga world. can i ask - what is meant bt timing closure? does it anyway relate to mee...
2 comments posted 22yrs
posted by shyan
2 comments posted 22yrs posted by shyan