cadence nc tools

Hi freinds

I am new to Cadence nc tools. I am using the gui. everytime I modify my code, I have to reinvoke the simulator window. Is there any simple way where I can modify my code with my simvision window open. At present every time I want to change the code I have to close my cadence simvision gui window, compile and elaborate it and then again simulate it which reinvokes the simvision gui and finally select the signal of interest and send them to the waveform window. Its realy painful and I am sure there will be some solution to it which I dont know.

Thanks Rik

Reply to
rik
Loading thread data ...

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.