hello,
Iam designing a pcb layout for one circuit , i want to pour all the layout and attaching to GND net once one problem has came after drawing copur pour obstical it was not visiable.how to make it visable?
orcad designing
Aug 30, 2006
2 Replies
Your pour must have a net name that is the same as a pin that it will connect to. If your pour doesn't touch a pin with the same net name, Layout will not show the obstacle. This is a problem in Layout.
Two ways to solve this:
- You must go to the obstacle spreadsheet and delete the obstacle
- Temporarily move a component that has the same net name as your obstacle into the obstacle area that you can't see to make the obstacle visible.
Mark
dera sir
Thanks for your answer.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required