Field-Programmable Gate Arrays

15255 Threads Posts
to

Spartan 3 POR Spec?

I'm looking at designing with Spartan 3. The data sheet says the power-on-reset timing ranges from 5-7ms. Does anyone h...
1 comments posted 22yrs
posted by stevesmith_98
1 comments posted 22yrs posted by stevesmith_98

ICAP with microblaze

Hi, Does any one used ICAP with Microblaze? I am trying to read some frames using documentation from XAPP662. I modifie...
1 comments posted 22yrs
posted by iarunkumar
1 comments posted 22yrs posted by iarunkumar

PCI Express specification.

Hi, there: I am looking for PCI Express speficitaion...May I know where I can get it besides the PCI SIG? I have no memb...
6 comments posted 22yrs
posted by kelvin8157
6 comments posted 22yrs posted by kelvin8157

Bus interface?

Hey i was wondering if any one had any idea how to create some sorta bus interface that would communicate between a FPG...
2 comments posted 22yrs
posted by tyron123
2 comments posted 22yrs posted by tyron123

DDS-Based PLL

An alternative using a conventional VCO-based PLL with an FPGA would be to implement most of the PLL as a DDS. The FPGA...
11 comments posted 22yrs
posted by kevin_neilson
11 comments posted 22yrs posted by kevin_neilson

System Generator HDL co-simulatin problem

Hi, I am using system generator 6.1 withing Matlab 13 and ISE 6.1 and modelsim 5.7d. When i run a HDL co-simulation of...
4 comments posted 22yrs
posted by benkhalh
4 comments posted 22yrs posted by benkhalh

Price of a Virtex-2 6000 chip...

Hi, there: I was browsing through my emails and discovered a dude claiming a xc2v6000 costs US$4000 and a xc2v8000 for U...
1 comments posted 22yrs
posted by kelvin8157
1 comments posted 22yrs posted by kelvin8157

Help - DDS Control in Virtex II

Hi All, I am not looking for an easier answer (unless one wants to offer it :-)) as I am looking for a good source to l...
1 comments posted 22yrs
posted by dodgepickup318
1 comments posted 22yrs posted by dodgepickup318

pi/4 DQPSK demapping

In a project at university, I'm using 2048 pt FFT core from Xilinx CoreGenerator and the output data are modulated with...
0 comments posted 22yrs
posted by kyrten
0 comments posted 22yrs posted by kyrten

Writing PCI constraints in Altera

Hi, I am fairly new to FPGAs. I am trying to write the constraints for the PCI module on an Altera Stratix device. I am...
9 comments posted 22yrs
posted by tushitjain
9 comments posted 22yrs posted by tushitjain

New test of ISE 6.2 w/ SP#2

It takes about 8 minutes to finish PAR. ISE 6.1 SP#3 is about 10 minutes. The design is for a XC2VP40-FF1152 with pins...
0 comments posted 22yrs
posted by qlyus
0 comments posted 22yrs posted by qlyus

VirtexII : XC2V2000 Design

Hello, I would like to design a card with one FPGA XC2V2000, two 18V04 and two ZBT RAMs of 512*36 each... Could you hel...
5 comments posted 22yrs
posted by drms
5 comments posted 22yrs posted by drms