Field-Programmable Gate Arrays

15255 Threads Posts
to

MXE post-translate simulation problem

Hello friends, i am using MXE, i got the post-translate simulation model (which gives us the filename_translate.vhd fil...
0 comments posted 22yrs
posted by saurabh541
0 comments posted 22yrs posted by saurabh541

VHDL code for Type and Components

Help! I have a state machine on my top level for an SRAM controller. The states are sram_state_read, sram_state_write,...
2 comments posted 22yrs
posted by bradsmallridge
2 comments posted 22yrs posted by bradsmallridge

Newbie, Altera vs Xilinx

Hi! I'm completely new to FPGAs and now I want to buy an eva-board to learn about them. What is the right device to sta...
2 comments posted 22yrs
posted by somewhere
2 comments posted 22yrs posted by somewhere

Xilinx : Memory-Compiler for DDR-1

Hi, I just found and tried to evaluate the xmil007 memory-intercae compiler for the Spartan-3 and the recent Virtex dev...
0 comments posted 22yrs
posted by brandt
0 comments posted 22yrs posted by brandt

Coregen difficulties with DCT

Has anyone used the DCT core available in Xilinx ISE 6.1's coregen? I am currently getting the following error message...
2 comments posted 22yrs
posted by <brandon
2 comments posted 22yrs posted by <brandon

Daft RapidIO question

anyone have problems instantiating the verilog simprims (x_inv or x_lut2, etc) in the phy_8_lvds before? Even though I...
2 comments posted 22yrs
posted by yyy
2 comments posted 22yrs posted by yyy

RapidIO functional simulation

Has anyone ever had issues with the RapidIO verilog functional simulation off the Xilinx site? Even though I have my si...
0 comments posted 22yrs
posted by yyy
0 comments posted 22yrs posted by yyy

Use Xilinx VP20 with 2 ppc and one DRAM chip

What's the easiest way to partition one 128 MB dram into two 64 MB sections with each section control by one of the ppc...
6 comments posted 22yrs
posted by tony.p.lee
6 comments posted 22yrs posted by tony.p.lee

Spartan 3 Kit

Where is the demo software for this wonderful Spartan 3 kit? I was most surprised when I plugged in a VGA monitor and s...
4 comments posted 22yrs
posted by bradsmallridge
4 comments posted 22yrs posted by bradsmallridge

PPC cores and XAUI core on Xilinx Virtex-II Pro 20

Hi, I am trying to find out if there are any restrictions to using both the PPC cores in the Virtex-II Pro device as we...
0 comments posted 22yrs
posted by huzaifa.ginwalla
0 comments posted 22yrs posted by huzaifa.ginwalla

Sine function implementation in FPGA

Hi all, I am trying to implement a DSP algorithm in a FPGA. My algorithm has sine and cosine functions in it. Can someb...
2 comments posted 22yrs
posted by sourabh.dhir
2 comments posted 22yrs posted by sourabh.dhir

Daft modelsim question

I'm trying to simulate some Verilog to run on my XPort card. The card plugs into a Gameboy, so any configuration of its...
3 comments posted 22yrs
posted by twomack
3 comments posted 22yrs posted by twomack

3.3 V ref VCC on Xilinx AFX FF1152 board?

Hi there, I have a Xilinx AFX FF1152 Xilinx 2 Pro development board, and I have a design which drives a set of pins to...
0 comments posted 22yrs
posted by mwd24
0 comments posted 22yrs posted by mwd24

Flex10K10A, I2C, MultiVolt IO, pull-ups

Dear experts, We have a PIC MCU, an Altera Flex10k10 (EPF10K10ATC100-3) and a serial EEPROM connected to a I2C bus. The...
5 comments posted 22yrs
posted by m.fuchs
5 comments posted 22yrs posted by m.fuchs