Altera Cyclone Serial Configuration devices.

I started reading some documents about the configuration devices EPCS1 & EPCS4. They appear to be programmed with a new download cable, the Byteblaster2. The Byteblaster2 claims compatibility with the previous models, the Byteblaster and the ByteblasterMV. Unfortunately, there is no schematics included in the Byteblaster2 datasheet. Is the 74HC244 being changed to a 74LV244 this time ?

Rene

--
Ing.Buero R.Tschaggelar - http://www.ibrtses.com
& commercial newsgroups - http://www.talkto.net
Reply to
Rene Tschaggelar
Loading thread data ...

Byteblaster2 is a superset of MV -- more than a buffer. But I expect that the MV can program an EPCS1.

-- Mike Treseler

Reply to
Mike Treseler

I believe there's an extra pin so the two aren't quite forward compatible.

Reply to
Simon Peacock

A link to the schemtaic for the ByteBlaster II was posted on this site a while back !!

Reply to
Ben Popoola

Thanks. I have all messages 3 month back and was to find it. One paper claims to redo BBMV into BB2, but without 1.5V. The other, ... I'll have a look at them anyway.

Rene

--
Ing.Buero R.Tschaggelar - http://www.ibrtses.com
& commercial newsgroups - http://www.talkto.net
Reply to
Rene Tschaggelar

-- Hi

BB2 MUST be used to configure both EPCS1 and EPCS4 using the AS scheme.

Cheers,

Rich.

Reply to
Richard Temple

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.