Electronics Repair

21792 Threads Posts
to

Schematic needed: Austroflamm WEGA stove

Looking for a schematic for a AustroFlamm WEGA Pellet Burning stove...the electronics that drive the pellet-feed auger a...
2 comments posted 20yrs
posted by stanleyh
2 comments posted 20yrs posted by stanleyh

Sharp 21" starts up and shuts down

I am trying to repair a Sharp 20MH10 21" TV with the following symptoms: (1) When the power button is pressed, makes a...
1 comments posted 20yrs
posted by mine_only_mine2222
1 comments posted 20yrs posted by mine_only_mine2222

Identify the ST Diode: BUX

I have a bad diode. The part number is: ST BUX C0 49 C0 49 is the week and year, ST is the manufacturer, BUX is the par...
0 comments posted 20yrs
posted by saturnlee
0 comments posted 20yrs posted by saturnlee

Sony 32" dead again.

KV-32S40 dead, replaced horiz output, MX regulator IC, & resistor. VDR on separate power supply board measured open...s...
3 comments posted 20yrs
posted by greeben
3 comments posted 20yrs posted by greeben

vertical output stage

I am looking for some information so I have a better understanding to argue my claim against the power company for dama...
15 comments posted 20yrs
posted by carolynoneill21
15 comments posted 20yrs posted by carolynoneill21

Panasonic CT32 TV

This set shuts off and normally restart on its own. Could be after 4 mins operation or 3-4 hours operation. Otherwise pi...
1 comments posted 20yrs
posted by rld451
1 comments posted 20yrs posted by rld451

O-scope Help

Does Anyone Know Where I Can Find An O-scope For Fairly Cheap. I Was Looking At Pc Based Scopes. Does Anyone Know Of An...
3 comments posted 20yrs
posted by russellsh.21hrn9
3 comments posted 20yrs posted by russellsh.21hrn9

Hyundai Car Deck Stuck!

Recently I was playing my stereo in my 2002 Hyundai Santa Fe and suddenly the cassette deck stopped working and giving...
2 comments posted 20yrs
posted by brian
2 comments posted 20yrs posted by brian

Receiver Control Panel

Hello- I'm not sure if this is the right forum for this question, but here goes. I am putting together a stereo cabinet...
8 comments posted 20yrs
posted by afinpdx
8 comments posted 20yrs posted by afinpdx

LCD TV Repair - Need Advice...help!

Hi - Does anyone know if an LCD screen with dead pixels (that form a dotted line) will get worse over time (develop mor...
4 comments posted 20yrs
posted by pokee
4 comments posted 20yrs posted by pokee

Dead Ctc203

I Have An Rca Ctc203 Tv That Is Dead. According To The Owner The Tv Would Intermitently Shut Off, And If You Hit The Si...
6 comments posted 20yrs
posted by russellsh.21hrn8
6 comments posted 20yrs posted by russellsh.21hrn8

Sony CDP 671 CD, working now, but?

No troubles for owner then totally stopped on next disc or any others. Laser alight , cleaned lens, mechanics seemed ok...
8 comments posted 20yrs
posted by diverse8
8 comments posted 20yrs posted by diverse8

MItsubishi VS-50605 Inputs not working

Hi, I have a Mits VS-50605 Tv, and The composite inputs, as well as the tuners(both of them) , stopped working (no pict...
1 comments posted 20yrs
posted by hugeboy_98
1 comments posted 20yrs posted by hugeboy_98