Weller Ec1002 schematic

You already posted this request further down, and I already pointed you one place that at least carries the spares, and has an on-line spares listing ...

Arfa

BILL -

Much of my Weller documentation is on BAMA Mirror -- LOOK here:

What do you need?? IF you are trying component repair on the surface mount, good luck. IF you have an OLD ceramic board -- look at EC242 -- that will give you some ideas - from my reverse engineering. The IC was a proprietary Weller design (I think Signetics made them for CopperTools/Weller)

EC234 - Plug-in heater for EC1201 iron EC226 - Temperature sensor (Type K Thermocouple) for EC1201 iron

I do have spare EC1002 Control Boards -- reliable Series 3 (fiberglass boards) I use for restorations/repairs.

EC1002 is a good station -- although Weller had issues with a ceramic control board approach (trying to prevent Far East copy cat deisgns) in early models. Approach worked -- copy cats went and copied the Hakko design!!

g. beat w9gb

I find this 12-06-2003, 06:19 PM 2003 poting from you to be of great interest .....did you lose those doucments in past 5 years?

=============

I'm looking for a schematic for a Weller EC1002 soldering station. If anyone can help please email me at [removed for spam protection] for any help you may give me.

Bill