Field-Programmable Gate Arrays

15255 Threads Posts
to

OT: Block diagramming tools?

Ok, This is slightly off-topic but what do people in here use to create their digital logic block diagrams? I am hopefu...
3 comments posted 23yrs
posted by se10110
3 comments posted 23yrs posted by se10110

altera latch synthesis

Hi all, I'm working with Quartus II 2.2 sp2 and my target fpga is APEX20KE. I have described a latch in my VHDL code wi...
5 comments posted 23yrs
posted by NSP_g.cocchi
5 comments posted 23yrs posted by NSP_g.cocchi

Re: Input comparator

Peter, Austin! Nobody can help me? Luiz Carlos
11 comments posted 23yrs
posted by oen_br
11 comments posted 23yrs posted by oen_br

EDK problem!

Please does anyone have experience with EDK 3.2 for embedded design? I am trying to make my microblaze processor to be...
9 comments posted 23yrs
posted by john
9 comments posted 23yrs posted by john

Re: Xilinx Foundation Series 2.1i on Linux

> Hi, have anyone successfully installed Xilinx Foundation Series 2.1i on > Linux? > > I've tried doing so, but without...
1 comments posted 23yrs
posted by roger.larsson
1 comments posted 23yrs posted by roger.larsson

Matlab: What do I need for modeling?

I'm not intimately familiar with Matlab, and I'd like to know which pieces I need for a project. Normally I get filter...
0 comments posted 23yrs
posted by kevin_neilson
0 comments posted 23yrs posted by kevin_neilson

Altera Devices

Hi ! Is this possible, to implement function with 4 inputs, 1 output using also DFFE component with clk, ena and preset...
4 comments posted 23yrs
posted by mkazula
4 comments posted 23yrs posted by mkazula

Partial Reconfiguration : 2 reconfig modules

I'm trying to make a project with 2 reconfig modules. I am using LUT's inside each module to create constant values (I...
4 comments posted 23yrs
posted by
4 comments posted 23yrs posted by

DDR capabilities of a Virtex II device

Hi, I have a Virtex II -5 and I would like to use the DDR registers in the IOBs. I read a few application notes involvi...
1 comments posted 23yrs
posted by jfhasson
1 comments posted 23yrs posted by jfhasson

parallel port

I tried to connect my fpga board through a parallel cable to my PC - when i run boundary scan mode in IMPACT, it doesn'...
2 comments posted 23yrs
posted by simone.winkler
2 comments posted 23yrs posted by simone.winkler

Virtex-E Select-RAM refresh rate

Hello, I have a custom-made FPGA-board with a Xilinx Virtex-E (XCV-300E) FPGA. I'm trying to measure the FPGA's power c...
1 comments posted 23yrs
posted by stefanti
1 comments posted 23yrs posted by stefanti

BlockRam @ 333MHz

Hi all, I'm using a VIIpro (P30, -5). My data needs to be buffered before going to the DDR memory. The DDR databus widt...
0 comments posted 23yrs
posted by iolo
0 comments posted 23yrs posted by iolo

Complex digital ICs visual simulation?

Hi there! If I e.g. place a RAM component into MultiSim, will it simulate it? I.e. can I (using switches and hex displa...
2 comments posted 23yrs
posted by NOSPAM
2 comments posted 23yrs posted by NOSPAM