Field-Programmable Gate Arrays

15255 Threads Posts
to

Changing directory name in Quartus

Hi, I have a directory called "TOP_PROJECT" in which I have several submodules. These submodules include VHDL files amo...
3 comments posted 22yrs
posted by ALuPin
3 comments posted 22yrs posted by ALuPin

xilinx ngdbuild old command flow problem

I'm using ise webpack 6.2.03i through wine on redhat 9. After xst, when I tried to run ngdbuild i got the follwing mess...
3 comments posted 22yrs
posted by accellera2
3 comments posted 22yrs posted by accellera2

Altera FPGA's

Hi, Does anyone have any experience in programming Altera FPGA's? In particular a FLEX8000. What development environmen...
3 comments posted 22yrs
posted by Ed
3 comments posted 22yrs posted by Ed

Area constraint on a sub-module

Hi, Can anyone suggest how to assign a area constraint on a sub-module within my design? I dont care where the other su...
3 comments posted 22yrs
posted by vramtilak
3 comments posted 22yrs posted by vramtilak

Altera DEMUX Megafunction - does it exist ?

There is a nice parametarizable MUX but how about a DEMUX ??? I have already implemented my own 1-bit 4-input DEMUX, bu...
1 comments posted 22yrs
posted by vbishtei
1 comments posted 22yrs posted by vbishtei

Open Collector Circuit - How to Simulate?

Hi all, I need Open Collector Active-Low analog circuit's logical representation. I am having pretty hard time putting...
3 comments posted 22yrs
posted by dhruvish
3 comments posted 22yrs posted by dhruvish

32-channel PC-based logic analyzers

Hi, Can anyone recommend any good (and cheap) 32-channel analyzers? By cheap I mean less than or approximately $1000. I...
12 comments posted 22yrs
posted by ernielin
12 comments posted 22yrs posted by ernielin

Xilinx XC9500 CPLD internal pull-up??

Hello! Does anyone know if the Xilinx XC9500 has internal pull-ups (or pull-downs...) when in normal mode (programmable...
3 comments posted 22yrs
posted by bmscc
3 comments posted 22yrs posted by bmscc

Boards Comparable to Alpha-Data's ADM-XRC-II

I am looking for boards that are comparable to the ADM-XRC-II. It is a high performace PMC designed for supporting deve...
0 comments posted 22yrs
posted by bodnar
0 comments posted 22yrs posted by bodnar

Xilinx FPGA Die Size

Fellow comp.arch.fpga users, I'm trying to obtain information die sizes for various Xilinx FPGAs in the Virtex, Virtex-...
1 comments posted 22yrs
posted by rfong
1 comments posted 22yrs posted by rfong

IDE or ATA controler on a Fpga

Hi everybody, I would like to know if someone has already build a IDE or ATA controler on a FPGA (any kind Xilinx or Al...
3 comments posted 22yrs
posted by david
3 comments posted 22yrs posted by david

Using Verilog to embed the synthesis date and time

Does anyone have a simple way to embed the date and time that a module is compiled into a wire or register in Verilog?...
6 comments posted 22yrs
posted by johnp3+nospam
6 comments posted 22yrs posted by johnp3+nospam

PLL phase after compensation

Hi, I have the following question concerning PLL use in Altera Cyclone devices: In normal mode it said that the PLL pha...
2 comments posted 22yrs
posted by ALuPin
2 comments posted 22yrs posted by ALuPin

fpga board with audio in/out (xilinx fpga) ?

Hello I'm searching for a FPGA board for about $500 with an "audio in" and "audio out" port... adequate for audio proce...
2 comments posted 22yrs
posted by timo.dammes
2 comments posted 22yrs posted by timo.dammes

Warning During Simulation

Hello, I am getting follwing warning while I simulate (Post Lay out simulation) my design using Modelsim # ** Warning:...
0 comments posted 22yrs
posted by t_naimesh
0 comments posted 22yrs posted by t_naimesh