Field-Programmable Gate Arrays

15255 Threads Posts
to

PLL Clocks on Cyclone Devices

Can a Cyclone PLL accept a clipped sine wave with an amplitude of 0.8V - i.e. what is the maximum rise time on the edge...
2 comments posted 22yrs
posted by ian.mcneil
2 comments posted 22yrs posted by ian.mcneil

ISE and Clocks

Hi everyone, I had a question in regards to the Xilinx ISE. I have a design in which i use synopsys for synthesis. Then...
1 comments posted 22yrs
posted by
1 comments posted 22yrs posted by

FPGA board checking

Hello, I am developing a FPGAs (BGA case) board. Is it possible to check the connections between two pins on two differ...
5 comments posted 22yrs
posted by pas
5 comments posted 22yrs posted by pas

Low-power FPGAs?

I am working on an instrument that currently uses a 300 MHz TI dual- issue DSP + A/Ds + a micro. Under "normal" use, I...
76 comments posted 22yrs
posted by localhost
76 comments posted 22yrs posted by localhost

ISE Mapping problem

Hello there, I've got a hard-wired asyncrhonous reset coming into GCK on a Spartan XC2S200 device. The reset is used wi...
1 comments posted 22yrs
posted by yaseenzaidi
1 comments posted 22yrs posted by yaseenzaidi

Virtex-II Pro DDR Memory Controller

I've been working on a DDR SDRAM controller for a Virtex-II Pro 7 (ff896 package, speed grade 5) So far I've tried the...
1 comments posted 22yrs
posted by mmdst23_NOSPAM_
1 comments posted 22yrs posted by mmdst23_NOSPAM_

SCSI

Has any tried to write a SCSI core?
1 comments posted 22yrs
posted by me.hates:spam
1 comments posted 22yrs posted by me.hates:spam

PacoBlaze 1.3b

Hello people. Just to inform you that PacoBlaze 1.3b is out. The are no changes to the KCPSMx cores, KCAsm has been enh...
6 comments posted 22yrs
posted by pablobleyer
6 comments posted 22yrs posted by pablobleyer

Hello Xilinx folks -- please answer

When will the design sources for the ML401 demo projects be available? Thanks
8 comments posted 22yrs
posted by pete
8 comments posted 22yrs posted by pete

Q: configuring FPGA Spartan2

Hy! I would like to make board with Spartan2 (exactly XC2S50-5PQ208), and that FPGA must be configured in master serial...
4 comments posted 22yrs
posted by ivan.koprivnic
4 comments posted 22yrs posted by ivan.koprivnic

System Generator problem with XtremeDSP

Hello, I want know if it is possible co-simulate with hardware-in-loop the xtremedsp kit II, if I use ADC and DAC. Alway...
0 comments posted 22yrs
posted by tmsiqueira
0 comments posted 22yrs posted by tmsiqueira

VCXO Emulation

I am targetting an S3 and need a VCXO. This can be done by permanently rotating the delay in the DLL. Unfortunately the...
5 comments posted 22yrs
posted by thomasREMOVE_rudloffREMOVE
5 comments posted 22yrs posted by thomasREMOVE_rudloffREMOVE

Altera NIOS2 flash prgrm port

Hi, I am trying to port the NIOS2 flash programmer to a new development board, but have the following problems: 1-if i...
2 comments posted 22yrs
posted by spamrprovo
2 comments posted 22yrs posted by spamrprovo

Xilinx and Altera Modelsim on the same PC?

Hi all, I've been using Altera parts and tools for quite a while and currently have Quartus-II 4.1 on my PC along with...
0 comments posted 22yrs
posted by creon100
0 comments posted 22yrs posted by creon100