I'm working with a Xilinx board (Spartan XC3S2000) and I can't program Flash Eprom. I'm using iMPACT software. I have generated a configuration file for Eprom and I load it on Eprom. But it doesn't work. When I disconnect my parallel cable IV and set jumpers, my board does not read eprom program. Can someone help me please? How have I to set jumpers?
Xilinx Prom programming
May 05, 2005
2 Replies
finding old archives might help you. i think there had been some relevant discussions in past on this topic.
regards, $hreya$
Make sure M0~M2 are set correctly to read config flash at FPG startup
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required