I bought a HP 1631D logic analyzer and realized that they do not come with the ribbon cable/header for the probes' connector.
The model number for the probes 10271A, 10272A and they are both 11-pins. Does any body know what are the model numbers of those connectors/adaptors and how can I find them?
Thanks in advance.
Cheers, Hoi
Hoi,
These are fairly difficult and expensive to obtain. However, the distance between the pins is 3.96mm (0.156") - and there are standard Molex connectors which would fit.
11 pin Molex connector 09-50-7111 ( Mouser P/N 538-09-50-7111 ) Molex terminal 08-52-0113 ( Mouser P/N 538-08-52-0113 )If you go to the mouser website with these #s, you can get to the Molex website for datasheets. I used these for a while, untill I got the real connectors through an ePay auction. However, the connectors are rarer than the Logic Analyzers. You can find HP's numbers by going onto the Agilent website and downloading the doc for this logic analyzer. I used to know the #'s, but I sold my 1631D and bought a 1652B...
Maurice
Hi Maurice,
Thanks. I looked at:
and I found two numbers:
10271-63201: Clip Asy-10 Chan 5959-0288: Grabber AssyWhich one describes the header that I'm looking for? I'm not sure that thing is called a clip or grabber.
Thanks.
Cheers, Hoi
Hoi,
The grabber assembly are the individual clips for connecting each wire. These or equivalent ones are reasonably easy to obtain. You need:
10271-63201 (3 or 5) and 10272-63201 (2 or 0) for your 1631D. These clips are very hard to find.Thanks,
Maurice
Thanks a lot for the pointer. I really appreciat it :)
Have something to add? Share your thoughts — no account required.
Ask the community — no account required