Xilinx ISE 6.1i+SP2 And Modelsim 5.8

- P
- Peng Cong
  
  Contact options for registered users
posted
20 years ago

Mon, Nov 24, 2003 1:12 AM

Hi all I have a problem with Modelsim simulation. When I use Modelsim 5.7f, I creat a project under ISE 6.1i+SP2, set Simulator value to Modelsim, it's fine. But yesterday after I upgrade Modelsim to version 5.8, when I open the project, it said that "This project was last saved with the project property 'Simulator' set an unvalid value of 'Modelsim'". How can I solve this problem? Thanks for any advance

Loading thread data ...

- M
- Mike Treseler
  
  Contact options for registered users
Vote on answer
posted
20 years ago

Mon, Nov 24, 2003 7:17 PM

try a

vcom -refresh

from your source directory.

Consider calling vcom and vsim from the command line instead of using the gui project manager.

-- Mike Treseler

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.