Electronics Repair

21771 Threads Posts
to

Cypress CP5609AMT

I would like to modify a dead mouse into a LED power. The chip would not activate the LED input until the PC boots into...
3 comments posted 15yrs
posted by toylet.toylet
3 comments posted 15yrs posted by toylet.toylet

reparing battery pack

When I rebuild my drill battery pack with new C nicads do I have to stay in the same mAh rating. The originals are 1300...
16 comments posted 15yrs
posted by LSMFT
16 comments posted 15yrs posted by LSMFT

Fairchiled KA5L0165R source?

Anyone know of a source in the UK or an equivalent? The eEquipment dates from about 2005, datasheet from 2003 http://pd...
0 comments posted 15yrs
posted by rootpassword
0 comments posted 15yrs posted by rootpassword

Confusing output voltage from transformer

I have a very small sony amplifier (the portable type such as you would travel with and attach to an Ipod). I dont have...
15 comments posted 15yrs
posted by bluestar09555
15 comments posted 15yrs posted by bluestar09555

Search EPROM 1Mb

Hello to everyone, I'm searching for some ST M27C1001-20XFI or similar (32pin, 1Mbit, 128Kx8, 35ns) I'm from Italy, ple...
0 comments posted 15yrs
posted by andreapier
0 comments posted 15yrs posted by andreapier

Boss ME50 multi effects pedal

All LED flash on &off then latches up with the seven segment display showing the decimal point only. Removed the single...
1 comments posted 15yrs
posted by diverse
1 comments posted 15yrs posted by diverse

Unidentifiable washing machine klixon

Does anyone know who makes these ? http://www.teaser.fr/~amajorel/lf1200/files/lf1200_klixon1.jpg http://www.teaser.fr/...
8 comments posted 15yrs
posted by cheney
8 comments posted 15yrs posted by cheney

Harmon Kardon Citation 5.0 controller

I went on a home theater call yesterday and found that this unit seemed to be stuck in standby mode. I was just seeing...
0 comments posted 15yrs
posted by captainvideo462009
0 comments posted 15yrs posted by captainvideo462009

Slide projector - discharge lamp light source?

Anyone aware of a make / model that used mercury or other discharge lamp light source for conventional ie 35mm photograp...
14 comments posted 15yrs
posted by diverse
14 comments posted 15yrs posted by diverse

Fender SPL 9000 , 1997 slave amp

About half the solder joints on the input sub-board are bad. A .25 and M&F XLR each ch with no obvious reason why, as a...
2 comments posted 15yrs
posted by diverse
2 comments posted 15yrs posted by diverse

Adding RGB input to Sony Trinitron

I picked up a flat face Trinitron yesterday for peanuts. I plan to use this as an arcade game monitor (in a MAME setup)...
18 comments posted 15yrs
posted by boardjunkie1
18 comments posted 15yrs posted by boardjunkie1

Slightly odd output stage configuration. Thoughts ?

A muso customer has asked me to carry out some tonal mods to his Peavey Classic 30. All pretty straightforward cap chan...
31 comments posted 15yrs
posted by arfa.daily
31 comments posted 15yrs posted by arfa.daily