Pins...? Both the adaptor and the camera have a small hole with a post in it. Someone measured it for me, and said it was an unusually small measurement (I've temporarily misplaced the paper), something like
2.55? The adaptor says DC OUTPUT, and under that (from left to right)it says 6V then there's a line with 3 dots under it, then 2A, then under that it has a diamond with a horizontal line through it, connecting it to a circle with a smaller circle in it, which has a horizontal line coming out of it which goes to a diamond whith a + in it.
The camera says DC IN, under that it says 6V. Under that is the same 3 symbols, but the circle has a solid dot in it.
I've checked with everyone. The problem is they are an unusually small size. I think someone once mentioned 2.55 mm. Does that make sense? No one could find anything that small in any electronic catalogue. A friend said he could make a cable for me if we could get the plugs (or whatever they're called), but it seems they were custom made for this model of camcorder.
I just went to the URL and saw the three cables you're talking about; I've emailed the company asking about the cable. Thank you so much for the lead. I'll let you know if it pans out.
BTW, I found the measurement that a guy at an electronics store made of the holes that the plugs would go into. I was way off in what I wrote. The figures were 1.55 plug x 4mm center.
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here.
All logos and trade names are the property of their respective owners.