M # CT-32SL14J Ch # AP 411, relay just clicks on, & off repeatedly at plug in. Nothing gone in the power supply, or horizontal, & the SMPS isn't oscillating, getting almost no output on all secondaries. Looks like the Micro, & EEPROM are bad, & Panasonic Tech just confirmed this. The Micro is a 64 pin QIP. Pretty hard to change. Have you guys seen many of these sets go bad like this? Thanks, Dani.
Panasonic 32" dead.
Nov 23, 2006
1 Replies
quirk of fate
static event perhaps, or some random piece of iron filings/manufacturing solder balls shook loose and went where it should not have
these things usually just dont fail like u describe
or could be one of those chip failures of the 1 in ten million of the MTBF actualy occured, & u the winner!
i would surmise it was a power glitch or out of bounds power supply excursion that did the nasty.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required