Any ideas?
Fluke 77 dim LCD display
Jun 26, 2009
3 Replies
I had a couple of them just this morning. Dave
Simply lifting the display from the board and cleaning the contacts on the board will often fix the problem.
Cleaning the contacts on the LCD is more "iffy". If you have to do it, you should soak a foam swab in solvent, then "roll" it over the contacts (rather than rubbing it).
Clean the zebra strips. Mine is a little brown but very visable. But it'salso 25 years old.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required