Hi. I've had a blinking AUTO in the front window, and it wouldn't load a tape. I replaced the mode switch, and it loads fine. However it won't go into play mode, nor will it rewind,FF or eject and I still have the blinking AUTO in the the window. Any ideas? Thanks. Mark.
AUTO blinking light on JVC VCR
May 25, 2006
7 Replies
Mark ha escrito:
Is, by chance, the recording timer accidentally set?
--------------------------------------------------------------
Home Page: http://www.seanet.com/~jasonrnorth
Checked voltages on the servo controller IC?
Mark: Take your factory remote & hold the power button down on it for 6 to 10 seconds (aim it at the VCR) , it should then power up and work properly. electricitym . . . . . .
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required