20 discussions on ElectronDepot about the Xilinx XC9536: what owners asked, what went wrong, and what fixed it.
I am looking for a PIC or Atmel Micro that has 4-independentlcontrolled PWM channels of about 10-bit resolution . The frequnenccan be the same but I need simultaneous 0-100% duty cycle control oeach channel independently . The max PWM...
Let's say we have an 8-Bit shift register. We reset it so that itsoutputs are as follows: 00000000We then set the data input high and clock it: 10000000We then drop the data input low and continuously clock it: 01000000 00100000...
Greetings.I'm looking at doing some basic CPLD designs via Schematic Entry. Whohas easier to learn/use schematic entry software, Xilinx or Altera?Both companies have CPLD's that meet my criteria, and designportability isn't an issue. ...
Hi folks,I have a fairly simple synchronous logic circuit, using a handful of flipflops and gates, which ordinarily I'd breadboard using HC TTL. However, it needs an 80MHz clock, which is too high for such families.I suspect I might need to...
Hello,I have been trying to figure out why the current draw of an XC9536 (not -XL) chip is so high. Xilinx has been of some help, but can't explain why the current I'm seeing (now 70 - 95 mA) is wildly higher than predicted by their...
does anyone have any information about this chip?I heard it mentioned in the same sentence as a 22v10 but I haventbeen able to dig up any pin outs/schematics online.Thanks