Field-Programmable Gate Arrays

15255 Threads Posts
to

Malfunctioning dual port block ram.

Hi, I have instantiated a dual port block ram through coregen with a 128 bit write only port and a 32 bit read only por...
6 comments posted 22yrs
posted by aniket
6 comments posted 22yrs posted by aniket

Drive strength on I/O pads

Hi all, I am targeting my design to XCS200 -5 fg256(SPARTAN device) . My OFFSET OUT timing constraints are very tight.S...
2 comments posted 22yrs
posted by praveenkn123
2 comments posted 22yrs posted by praveenkn123

Micro : Bus

Hello, I want to configure the Micro bus for our application. I am using a C167CS micro with the SpartanII. The bus is...
0 comments posted 22yrs
posted by izisling
0 comments posted 22yrs posted by izisling

Quality of timing simulation

Hello newsgroup users, I have made a timing simulation for my SRAM-Controller and an external asynchronous SRAM. I have...
0 comments posted 22yrs
posted by ALuPin
0 comments posted 22yrs posted by ALuPin

DLL - Change in input frequency (CLKIN)

Hi all, In my design, DLL is used to multiply the input frequency at the factor of 2. Since the input source clock is f...
5 comments posted 22yrs
posted by rajes_kumar
5 comments posted 22yrs posted by rajes_kumar

Atmel Zigbee solutions

Donald, Zigbee news from Atmel - what's key here, is a move from generic uC/Chip sales, into also selling the Zigbee SW...
7 comments posted 22yrs
posted by no.spam
7 comments posted 22yrs posted by no.spam

question about filter design vhdl

Hi, I have to design a low pass filter in VHDL. How can one go about designing such a filter when the medium is event d...
1 comments posted 22yrs
posted by daita
1 comments posted 22yrs posted by daita

Xilinx training

Hello, I am a junior FGPA designer and am planning on attending some training to improve my design skills and FPGA know...
3 comments posted 22yrs
posted by jaouque
3 comments posted 22yrs posted by jaouque

Clock Generation from Asynchronous Data Stream

Hello all... I am using a Xilinx Vitex II FPGA to unwrap a G.709 signal (OTU1) and output the underlying STM-16 (or oth...
2 comments posted 22yrs
posted by chlump
2 comments posted 22yrs posted by chlump

Xilinx Foundation [*.SCH -> *.VHD]

Hello, =20 There are some schematic files (*.sch) developed using Xilinx Foundation 4.2.=20 I am going to use those fil...
1 comments posted 22yrs
posted by EBEPriyanto
1 comments posted 22yrs posted by EBEPriyanto

Low cost FPGA dev board with high speed i/f?

Hi guys and gals, Could I call on your collective experience and expertise? I'd like to get hold of an FPGA development...
2 comments posted 22yrs
posted by davegoogle99
2 comments posted 22yrs posted by davegoogle99