Field-Programmable Gate Arrays

15255 Threads Posts
to

5V inputs with series resistor on Spartan-3

I was looking for information on driving Spartan-3 inputs from 5V CMOS signals using series resistors, and eventually f...
7 comments posted 21yrs
posted by eric-no-spam-for-me
7 comments posted 21yrs posted by eric-no-spam-for-me

Xilinx, VHDL, Verilog, ModelSim, BMP

I would eventually like to be able to read a BMP file directly into the ModelSim simulator. I understand now with VHDL...
26 comments posted 21yrs
posted by bradsmallridge
26 comments posted 21yrs posted by bradsmallridge

ModelSim

I launch Modelsim from the Xilinx IDE. I would like it run all the way through, to a wait; statement in the testbench....
1 comments posted 21yrs
posted by bradsmallridge
1 comments posted 21yrs posted by bradsmallridge

Xilinx EDK 6.3 : DDR Burst Mode

Does anyone uses the PLB DDR Chip on the PLB Bus of the PPC? Does anyone uses the burst modus. According to the xilinx...
0 comments posted 21yrs
posted by 00andi
0 comments posted 21yrs posted by 00andi

OpenCore USB 2.0

Yo! Does anyone know about about a port of an OpenCore USB 2.0 core to either Xilinx, Altera or plain vhdl (of reasonale...
2 comments posted 22yrs
posted by MLeFougueuxt
2 comments posted 22yrs posted by MLeFougueuxt

New Xilinx 6.3i from Prentice Hall ?

Hi folks, Prentice Hall is going to release Xilinx ISE 6.3i Student Version. http://vig.prenhall.com/catalog/academic/p...
0 comments posted 22yrs
posted by u1000393
0 comments posted 22yrs posted by u1000393

JTAG boundary scan xc2v6000

Hi, I´m thinking about using the internal TAP controller and the boundary scan chain of the virtex devices to test our...
1 comments posted 22yrs
posted by tirmen
1 comments posted 22yrs posted by tirmen

RocketIO clock recovery

Hi, I´m asking me if the REFCLK has a closer relationship to the recovered clock than mentioned in the user guide. Coul...
1 comments posted 22yrs
posted by tirmen
1 comments posted 22yrs posted by tirmen

Help with Virtex II and 5v TTL

Help, I've been trying to find a definitive answer to this question. Can I connect Virtex II pins configured as pure ou...
4 comments posted 22yrs
posted by geeja
4 comments posted 22yrs posted by geeja

Neural nets

I havent found a lot of information on current happenings relating to implementation of neural networks on FPGA. What I...
0 comments posted 22yrs
posted by paruchuri
0 comments posted 22yrs posted by paruchuri

Soft Processor Core

Hi ng, im searching for a soft processor IP core with the following capabilities: - Interrupt (more than one interrupt...
10 comments posted 22yrs
posted by stefan-oedenkoven
10 comments posted 22yrs posted by stefan-oedenkoven

LPM_MODOLUS warning

Hi, when compiling my project in QuartusII I get the warning: LPM_MODULUS input value is . It should be within the rang...
2 comments posted 22yrs
posted by ALuPin
2 comments posted 22yrs posted by ALuPin