Hooray! I have finally transfered my projects to ISE/EDK 8.2, with success.
*BUT*
Everithing works fine, except that I can't debug woth XMD and mb-gdb of version 8.2.02. When downloading the code it will always stop with the message: "Program Download failed trying to reset the Processor.."
But if I use XMD /mb-gdb from 8.1.03 and the code generated by EDK
8.2.02, I can work perfectly.
But now I am forced to use microblaze 4.00.a, as XMD 8.1.03 ddoes not understand microblaze 4.00.b. And I am limited in my possibilities to change firmware, as I should be forced to change both in 8.1 and 8.2 (and it may be impossiible)
Does anyonme know a solution or workaround to this problem? Or do I directly file a support case with Xilinx?
Best regards,
Zara