I've purchased the Memec V2Pro board and Xilinx EDK. Can I use my Parallel Cable III, or is the IV required? Thanks.
-Dave
Is Xilinx Parallel Cable III OK For Memec V2Pro / Xilinx EDK?
Apr 12, 2004
3 Replies
you should be good to go
Just to add to Matts reply... the parallel III cable should work fine for the VIIPro boards however it wasn't really intended for 2.5v JTAG - see here :
formatting link
The only other point to note is that the parallel IV cable is significantly faster than the parallel III
Regards,
-- Steve Merritt BEng (Hons) CEng MIEE XILINX Gold Certified Field Applications Engineer Insight MEMEC
Click link below for more information on : XILINX Free Training
XILINX Design Services
10 Gbps Serial IO on FPGAOr Tel - 08707 356532 for more information
I had this problem, and contacted Memec tech support. The fix they suggested, is dissconnecting Vcc (red wire) from JTAG and connect directly into 3.3V on JP29. This works for me.
Remis
************************************************
To reply, remove >.spam< and >.fake<
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required