I just bought a tek 576 from a leasing company works but has focus problem anyone with maintenance manual around in pdfs .... best regards patrick
tektronix 577 & 576
May 05, 2006
6 Replies
For the 577 (not 576) see: ftp://bama.sbc.edu/downloads/tek/577-177-d1/
"David C. Partridge" wrote in news: snipped-for-privacy@pipex.net:
Not anything similar.577 is based on the 5100 series scope chassis and display,the older 576 is WAY different.
Perhaps a bad resistor in the focus string?
Jim Yanik
jyanik
at
kua.net
Hi Patrick,
yout topic is a little misleading because you mention both the 577
*and* 576.Do as Jim recommended. Check the HV area and the focus restor chain of your 576.
The 577 diagram (or very similar in the HV area: 5100 scope diagram) might be helpful to get a genral impression how Tektronix curve tracers are set up in this area around the CRT.
Fotr the 577: David's hint is valuable.
hth, Andreas
"carneyke" wrote in news: snipped-for-privacy@i39g2000cwa.googlegroups.com:
and if the CRT is getting weak,it will naturally defocus;the beam is emitted from a larger area of the cathode.
Jim Yanik
jyanik
at
kua.net
¸÷?£¬×îÐÂ8?µÀÒôîl·ÖÎö?x£¡ºÃË?Ä?£ÓÐÅd?¿ÉÕÒÎ?¡
formatting link
Best regards,
Man Li AP Technology Ltd.
formatting link
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required