Embedded Programming

Which controllers are used most in display clusters application??

Hi, We want to decide about a development board for building Automotive Display Clusters(Dash Board) application. Few c...

1 comments posted 16yrs

posted by jpeeyush

1 comments posted 16yrs posted by jpeeyush

Ultra High Speed Type I Cards

The SD 3.0 standard states that UHS-I cards throughput can be up to 104 MB/sec in the SD104 mode. What confuses me is t...

0 comments posted 16yrs

posted by vijoeyz

0 comments posted 16yrs posted by vijoeyz

Digital pin used as analog pin

Hi, i want use a digital pin as analog output voltage: is it possible linear decrease voltage (maybe with a proper 1-0 c...

3 comments posted 16yrs

posted by silusilusilu

3 comments posted 16yrs posted by silusilusilu

Altera USB blasters as USB-SPI interface with ponyprog

hi a first version of the solution is available from its temporary home at my brains download area http://groups.google...

1 comments posted 16yrs

posted by antti.lukats

1 comments posted 16yrs posted by antti.lukats

nee

Yeah I also calculated 3 wait states. Is it 3 wait states per machine cycle or one wait state/MC(machine cycle)?. I hav...

1 comments posted 16yrs

posted by RIYAGIYA80

1 comments posted 16yrs posted by RIYAGIYA80

Use of MAX232 as power supply for operational amplifier in 5V powered system?

Hi, I need to add simple amplifier to my digital system which is powered from a single 5V battery. To achieve proper op...

7 comments posted 16yrs

posted by wzab

7 comments posted 16yrs posted by wzab

ROM wait states

can anyone explain me to calculate the wait states needed? Suppose we are using 120 nanosecond ROMs, which have valid d...

2 comments posted 16yrs

posted by RIYAGIYA80

2 comments posted 16yrs posted by RIYAGIYA80

Please tell me what is the cheapest ARM with my request ip(100K annual)

Please tell me what is the cheapest ARM with my request ip. Our company would like to change current audio application...

10 comments posted 16yrs

posted by rickeewong

10 comments posted 16yrs posted by rickeewong

dsPIC33 GPIO DMA

Is it possible to hook up a 16 bit parallel ADC to the GPIO pins on a dsPIC33 and have it stream into the DMA RAM? Thank...

6 comments posted 16yrs

posted by somewhere

6 comments posted 16yrs posted by somewhere

STM32, ADCs, Timing Problem

Hello Everyone, these days I encountered a serious timing problem using the ADCs, twice. Because of this the ADC interr...

0 comments posted 16yrs

posted by m.km

0 comments posted 16yrs posted by m.km

I2C Driver for DSP/BIOS

I've been in the embedded area for quite some time. I am currently running DSP/BIOS on a TI F2801. I am having trouble...

1 comments posted 16yrs

posted by e.krohne

1 comments posted 16yrs posted by e.krohne

ATE Test: how many push fingers?

Hi, I'm routing a board that will be tested by an Automatic Test Equipment line. I purchased and read the "SMTA/TMAG Te...

5 comments posted 16yrs

posted by zigbee

5 comments posted 16yrs posted by zigbee

Xilinx FPGA Not Being Recognized by ISE

Hello Everyone, I have a Sparkfun Xilinx FPGA Breakout Revision 2.2 with Support Circuitry(this one here: http://www.sp...

1 comments posted 16yrs

posted by xelapond

1 comments posted 16yrs posted by xelapond

Mensuration device parameterization scheme [VERY long]

Hi, Apologies in advance for the length of this post. :< But, it's probably an unusual design issue for most of the des...

8 comments posted 16yrs

posted by not.going.to.be

8 comments posted 16yrs posted by not.going.to.be

eio.com LCD panel 'hyper-email' list archive?

A few years ago eio.com hosted a really useful mailing list for people using LCD panels. It was a very busy list with l...

0 comments posted 16yrs

posted by theom+news

0 comments posted 16yrs posted by theom+news