Building a pulsoximeter project

Hello Everyone I am a final year student puruing my development project - 'Pulsoximeter'. After all the research I am at a stage where I have to design a pulsoximeter by using some sensors (Eg.TSL230R - Light to Frequency converter). I would be really grateful to someone who could suggest me a circuit design or even some resources which could be helpful in the design. I need a start to carry on the project. Thanks Akshay Gupta Manukau Institute of Technology

Reply to
apsolar
Loading thread data ...

Hi,

Why do you think that this light to frequeny converter is OK for you? did you really understand how Pulsoxy works and what the relevant parameters are? For solving the mathemetic you need at least 4 better 5 measurements in one pulswave. This means 2 wavelength and 2 timepoints. A light2f can not give you this informations, I guess.

Have a look in a few books[1] that describes pulsoxy and then think well abot that topic... I wont do such a project if I where you.

regards

MArte

[1] look about John G. Webster. He is one of the kings of biomedical engineering. His books are "must have" in a good library.
Reply to
Marte Schwarz

"Marte Schwarz" schrieb im Newsbeitrag news:ddq52j$4lk$ snipped-for-privacy@news2.rz.uni-karlsruhe.de...

in

Hallo Marte,

In sci.electronics.design läuft der gleich thread.

Fred Bloggs hat dort zwei passende Links angegeben. Einer passt 100%. Der zweite liefert das Basiswissen. Ob das für ein Gerät ausreichen würde das im medizinischen Bereich einsetzbar ist kann ich nicht beurteilen. Als Bastelprojekt sieht es aber (perfekt) gut aus.

Verfolge doch einfach den thread in sci.electronics.design.

Gruß Helmut

"Fred Bloggs" schrieb im Newsbeitrag news: snipped-for-privacy@nospam.com...

Reply to
Helmut Sennewald

Hi Helmut,

Daher kommt wohl auch die Schnapsidee mit dem Chip, Na ja, müsste man mal überdenken, aber sicher nicht so einfach wie beschrieben.. Fig 5 - grausig. Die Grundlagenseite ist ja auch ein wenig dürftig und Schaltungstechnis auch mehr rudimentär als professionell. Typisch Uni eben, von Leuten gelehrt, die im Ernstfall hoffentlich rechtzeitig spühren, wo der Lötkolben heiss wird... Mal sehen, ob ich noch was ausführlicheres finde.

Wenn ich richtig verstanden hab, sollte das ne Abschlußarbeit werden, und kein Bastelprojekt.

Mein Englich ist zwar grausig, aber ich werd mich da weiter äussern

Marte

Reply to
Marte Schwarz

Hallo Marte,

Macht nichts. Die meisten Leute dort stoert das nicht. Bei uns hier haben fast die Haelfte der Nachbarn einen kernigen Akzent. Wir auch, und unser Governator auch ;-)

Gruesse, Joerg

formatting link

Reply to
Joerg

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.