Hallo Leute, Nach Monaten der Fehlersuche läuft mein Eizo T660i-T dank Servicemanual wieder. Da die Anode total verdreckt war, habe ich den ganzen Dreck mit der Schmiere abgewischt. Testweise hab ich die Anode einfach wieder angesteckt (ohne Silicongel). Siehe da, der Monitor geht auch wieder. Der folgende Hinweis ist aus dem Manual:
Caution on Anode Lead Cap. When putting the CRT anode lead back onto the CRT, care should be taken as follows. (1)Anode button area should be neat and clean. Blow off all dust and dirt with compressed air if there are some noticeable after a work is done. (2)Silicone Grease, Shinetsu`s KS-650N recommended, should be applied equally around the area by a paint-brush. (3)Sbject area to be applied with grease is from 10mm from Anode button through 5mm beyond the Anode lead cap brim. (4)Anode lead hoock should be securely caught inside Anode button. (5)X-ray protection metal inside Anode lead cap, if the model is the subjekt type, should be securely stuck on the CRT's coated glass. (6)Anode lead cap shall be completely stuck on the surface and any partial tearing or lifting of it should not be recognized.
Jetzt die Fragen: Wo bekomme ich so ein "Silicone Grease" her ? Beim ansässigen Fernsehservicedienst war ich,der meinte das Zeugs ist schon dran, wenn er eine neue Kaskade einbaut. Siliconspray will ich nicht benutzen, die "Schmiere" sollte ja auch gegen ein paar kV isolieren und Staub, Feuchtigkeit usw. abhalten.
Und was ist ein "X-ray protection metal" etwa die kleine "Unterlegscheibe" zwischen den "Beinchen", die in die Röhre greifen, und der Plastikhaube ?
Danke schonmal, Gruß von Andy
PS:Gefahren durch die Hochspannung sind bekannt, Gefahr durch X-ray erst durch den Hinweis bekannt geworden...