historique de la discussion sur fr.rec.bricolage :
>>>
>>>> ne charge plus. L'icone indique "0%, pas en charge".
>>>>
>>>> semaines (Liitokala Lii-500, Message-ID: )
>>>>
>>>> batterie.
>>>>
>>>>
>>> une des puces de la batterie sur du Dell, mais pas moyen de le
>>> retrouver...)
>>>
>>
>
>
>formatting link
> ---------------------
> Reset Battery Controller When Replacing Battery Cells
>
> This procedure is required after you have replaced the batteries in the
> battery. In general, such a battery repair is carried out in service
> centers. It can be done at home, but for this you need to have the
> appropriate skills and experience, as well as the necessary equipment.
> The procedure for replacing battery cells is also called repackaging.
>
> After the elements are replaced, you need to reset the firmware or
> reset the laptop controller. The Battery EEPROM Works utility can be
> used for this. What the program does:
>
> Flash the residual capacity (Full Charge Capacity). You set it
> according to the real value. That is, for the controller, this value
> will become the actual capacity of these battery cells at the moment;
> The Cycles Count is cleared;
> The Manufacturer Date is set to the current one from your PC.
> ---------------------
>
>formatting link
>formatting link
>
> visiblement il faut une carte pour reprogrammer l'eprom...
un autre lien sur le sujet :
formatting link
le PCB/controleur : devant :
formatting link
formatting link
c'est jouable sans matos particulier ? j'ai peu d'espoir...