Electronic Components

Radioshack COUPON - take away from me $10 OFF

I have "$10 OFF COUPON"" for RADIOSHACK. In PDF-format, so can be emailed/printed anywhere; BUT it is to be used in sto...

0 comments posted 17yrs

posted by StanStar

0 comments posted 17yrs posted by StanStar

400-500V TO-92 etc npn / pnp BJT ?

It's a bit more than the usual voltage. The MPSA44 / 94 JUST makes it but the datasheet doesn't give hFE @ low Vce and...

9 comments posted 17yrs

posted by rabbitsfriendsandrelations

9 comments posted 17yrs posted by rabbitsfriendsandrelations

Momentary Switch Delay

I'm handy with a soldering iron, but I don't really know a lot about circuits. I could rig up a switch to turn on an LE...

8 comments posted 17yrs

posted by SantaAnaSlim

8 comments posted 17yrs posted by SantaAnaSlim

Trying to source 100027FR014S400TU - Apple's mini VGA connector made by suyin

Hi, Does anyone know where I can obtain some of apples miniVGA connectors - Suyin sell in lots of 10k - a few too many...

0 comments posted 17yrs

posted by srkh28

0 comments posted 17yrs posted by srkh28

Peltola coax connector?

This push-on connector is used in Tektronix equipment for board-to-board signal connection. Was it ever available outsid...

3 comments posted 17yrs

posted by me

3 comments posted 17yrs posted by me

Touching up black anodized alu heat sinks

You're bound to get scratches and scrapes when you buy these in bulk. Even handling/installing them can result in occas...

14 comments posted 17yrs

posted by oparr

14 comments posted 17yrs posted by oparr

"Insulgrip" hs tubing -- specs?

Googled but can't find voltage insulating value for HS-105 tubing. Anybody know the answer? Or point me to the manufactu...

11 comments posted 17yrs

posted by me

11 comments posted 17yrs posted by me

motorola bridge rectifier

someone posted a reply on diyaudio.com about motorola bridge rectifiers they listed the following:>>> Checking both the...

2 comments posted 17yrs

posted by mrfedup

2 comments posted 17yrs posted by mrfedup

ELO Remote OSD key wiring?

Hello, does anyone know what the innards are for the remote OSD controller for ELO touchscreen LCD monitors? There are...

2 comments posted 17yrs

posted by no-one

2 comments posted 17yrs posted by no-one

What cap mfr. to use?

Today I ordered electrolytic caps. It was frustrating. I had planned to get the best low-ESR replacements for all the c...

20 comments posted 17yrs

posted by me

20 comments posted 17yrs posted by me

Does RJ45 crimp tool also work on RJ11 & 4P4C plugs?

I'm thinking of getting a cheapo crimp tool for modular plugs. Would a crimp tool for 8-way modular plugs (RJ45) usually...

2 comments posted 17yrs

posted by spamtrap

2 comments posted 17yrs posted by spamtrap

Looking for the wiring diagram for Triplett 666-HH

I am looking for the wiring diagram for a Triplett 666-HH. Need it to fix the ohm circuit. I was able to get the wiring...

0 comments posted 17yrs

posted by makeit2day

0 comments posted 17yrs posted by makeit2day

Ferrite Pot Core

We're trying to find a replacement ferrite pot core. The core is just like the type shown in this picture: http://www.e...

6 comments posted 17yrs

posted by eletlabs

6 comments posted 17yrs posted by eletlabs

Low leakage capacitors

Hi, I'm trying to find the lowest leakage capacitor, somewhere in the range of 0.01uF to 1uF, *might* be able to live w...

5 comments posted 17yrs

posted by energymover

5 comments posted 17yrs posted by energymover

Nichrome Wire?

I'm replacing very tiny heating coils. It's about the size of a thread, maybe about .010" in diameter. I don't know exa...

4 comments posted 17yrs

posted by jwd0324

4 comments posted 17yrs posted by jwd0324