Electronics Repair

  1. Home
  2. Electronics Repair
21789 Threads Posts
to

Worth reading in Electronics Repair

Follow-up on connecting PC to TV with baluns

Thank you again Fin West and Peter D, I just got the balun transformer things from UPS today, and I hooked it up tonigh...
3 comments posted 16yrs
posted by NOPSAMmm2005
3 comments posted 16yrs posted by NOPSAMmm2005

CRT monitor vertical deflection problem

I have a TLC 14001 NTSC monitor that has a vertical deflection problem. The horizontal deflection is working fine. The...
4 comments posted 16yrs
posted by geeberry
4 comments posted 16yrs posted by geeberry

Would you buy this?

http://www.m2film.dk/fleggaard/trailer2.swf bob
5 comments posted 16yrs
posted by sound
5 comments posted 16yrs posted by sound

more legislative fun..

http://www.dealerscope.com/article/four-other-states-pursuing-energy-restrictions-similar-those-passed-california/1?spon...
21 comments posted 16yrs
posted by sound
21 comments posted 16yrs posted by sound

Sony HT-5500D receiver problems

This unit will come on and the protection display will come on. I have had the volume turned down and I have checked th...
1 comments posted 16yrs
posted by radiorascal34
1 comments posted 16yrs posted by radiorascal34

Racal 1992 counter fails initialization

This counter comes up with all the LEDs lit up and no buttons are responsive. Another one of these appears to have an i...
1 comments posted 16yrs
posted by chris
1 comments posted 16yrs posted by chris

Kyocera mono laser not feeding properly

Hi, I've had my Kyocera mono laser printer for about 6 years now, though its only on its second toner cartridge. The pr...
8 comments posted 16yrs
posted by sound.service
8 comments posted 16yrs posted by sound.service

Service Manual for Epson scanner?

Looking for the service manual for an Epson Perfection 1640SU scanner. I've found few for sale. Anyone have this file t...
4 comments posted 16yrs
posted by see
4 comments posted 16yrs posted by see

Manuals

I love this site! If you think I'm just some jerk looking for traffic, then don't go there. But I had good luck finding...
0 comments posted 16yrs
posted by jimjam1942
0 comments posted 16yrs posted by jimjam1942

Powering a 208-230 volt motor...question

Hello all... I was recently given a small furnace blower unit with motor. I'd admit that it was so small I made the ass...
1 comments posted 16yrs
posted by newsgroups1
1 comments posted 16yrs posted by newsgroups1

splitters with DC pass through, and dbs

Do splitters with DC pass-through have the same signal loss as those without. I've found vague things on the web and ju...
7 comments posted 16yrs
posted by NOPSAMmm2005
7 comments posted 16yrs posted by NOPSAMmm2005

LCD monitor turns off after a second

No bulged caps, anyone an idea what can cause this, i have 2 that do this, when the pic appears it looks good so no bad...
6 comments posted 16yrs
posted by sunnylion
6 comments posted 16yrs posted by sunnylion

Awkward IEC with integral fuse carriers

Just wasted 20 minutes trying to remove one, not the simple obvious type with a plastic latch under the drawer. This IE...
1 comments posted 16yrs
posted by diverse
1 comments posted 16yrs posted by diverse

Reviving Test Equipment After A Long Storage Period

I have a number of pieces of test equipment (HP, Tek, Fluke...digital/ analog/RF) that have been sitting in storage for...
6 comments posted 16yrs
posted by too_many_tools
6 comments posted 16yrs posted by too_many_tools