Electronics Repair

21792 Threads Posts
to

Question - Best way to determine charging status

I have a couple of hand held battery operated vacuums. The internal brass charging contacts that are suppose to make co...
4 comments posted 21yrs
posted by tnom
4 comments posted 21yrs posted by tnom

Philips/Mag 9P5511C101 PTV836

Got this one in for a PS opto and convergence. I wonder if these sets are needing coolant changes like other models fro...
0 comments posted 21yrs
posted by nospam
0 comments posted 21yrs posted by nospam

Motorola P10 Radius radios

I just got in for repair a few of these units that have defective base charger units. These are a circuit board with a...
0 comments posted 21yrs
posted by captainvideo462002
0 comments posted 21yrs posted by captainvideo462002

Good datasheet collection

Hi, In case you don't already know about it, there's a big collection of datasheets available for download at http://ww...
10 comments posted 21yrs
posted by bobpdeletethis
10 comments posted 21yrs posted by bobpdeletethis

Denon UDRA-90 help

Hi, I was wondering if anyone could tell me anything about the Denon UDRA-90 receiver amp? Searching through all the ma...
3 comments posted 21yrs
posted by tnnurseNOUCE99
3 comments posted 21yrs posted by tnnurseNOUCE99

john deere gx355

Any idea's on the cause and fix for engine starting as normal but stops as soon as the key is released?
4 comments posted 21yrs
posted by j-lowe
4 comments posted 21yrs posted by j-lowe

HDD magnets used to repair clothes dryer

I just had to post this. While ago the original hard drive went out in my pc. I replaced it & all went well, and since...
40 comments posted 21yrs
posted by prograd49NONSPAMMM
40 comments posted 21yrs posted by prograd49NONSPAMMM

Repair needed on obsolete cassette player

Hi, I have an Aiwa handheld cassette player that I would like to have repaired. Aiwa won't repair it (too old), and I c...
6 comments posted 21yrs
posted by johndrake
6 comments posted 21yrs posted by johndrake

10-lead stepper sanyo, bipolar?

hi! does someone know if i can run an bipolar stepper (10-lead, always 3 ohms between 2) also in "normal" unipolar mode...
0 comments posted 21yrs
posted by el.gigante
0 comments posted 21yrs posted by el.gigante

Digital LCD display defects ghosting

I have a handheld battery powered instrument with a LCD display that has a sort-of ghosting appearance (slow transition...
2 comments posted 21yrs
posted by kwag98
2 comments posted 21yrs posted by kwag98

Sony CCD-F77 camcorder problems

This camcorder had a scrambled pic from the camera head, and very poor color playback, so I recapped the entire unit, a...
3 comments posted 21yrs
posted by nospam
3 comments posted 21yrs posted by nospam