Electronics Repair

21792 Threads Posts
to

Advise for Repairing PSU for POS terminal

Hi, In need of advise for Repairing PSU for POS terminal? Input is 230V AC and Output: DC 5V/24V/12V/-12V/-19V with bac...
12 comments posted 20yrs
posted by jiunshyong
12 comments posted 20yrs posted by jiunshyong

Looking for Siemens Notephone experts

Hi, I'm looking for people who have knowledge about fixing a Siemens Notephone. This is a phone that was built around 1...
0 comments posted 20yrs
posted by spam
0 comments posted 20yrs posted by spam

Question about Weller AG700 soldering station

Hi all, could somebody who owns, or has access to, a Weller AG700 hot air soldering station please get in touch? Thanks...
3 comments posted 20yrs
posted by spam
3 comments posted 20yrs posted by spam

Toshiba Toughie

Hi, Toshiba model # CX21341 Chassis No. TAC 9117 Picture had bottom half missing and top was mostly retrace lines. Repl...
0 comments posted 20yrs
posted by Asimov
0 comments posted 20yrs posted by Asimov

Attempting audio amp (Pioneer A-9) repair - any tips?

My trusty Pioneer A-9 has a problem on the right channel. If I listen on the headphones the sound is great, on speaker...
11 comments posted 20yrs
posted by andrew.queisser at hp com
11 comments posted 20yrs posted by andrew.queisser at hp com

pc-uprog programmer schematics help

After ten years my old Advantech EPROM programmer PC-uprog stopped working. Does someone know where to find the schemati...
0 comments posted 20yrs
posted by microd.nospam
0 comments posted 20yrs posted by microd.nospam

Slow start-up JVC AV32WH3EP.

Hello, Ik have this TV and sometimes it wil not start, or starts slow. And sometimes it starts and after a few seconds...
0 comments posted 20yrs
posted by jantje niet
0 comments posted 20yrs posted by jantje niet

Good verses bad compact fluorescent lights -- inside?

Has anybody looked at the electronics inside compact fluorescent lights and found any differences between the good and...
15 comments posted 20yrs
posted by larrymoencurly
15 comments posted 20yrs posted by larrymoencurly

Transistor Fault Checking

Hi, Any advice on how come when a particular transistor when soldered gives out different readings as compared to when...
6 comments posted 20yrs
posted by jiunshyong
6 comments posted 20yrs posted by jiunshyong

Microsoft mouse repair tip

I have a Microsoft PS2/USB optical mouse I'm partial to, no longer available at retail, and right click stopped working...
2 comments posted 20yrs
posted by sunny
2 comments posted 20yrs posted by sunny

Replacement rubber belts

I'm looking for a couple of sources for rubber belts for consumer audio equipment. Does MCM carry belts? I didn't find t...
5 comments posted 20yrs
posted by nojunk
5 comments posted 20yrs posted by nojunk

Zenith Vertical Deflection Problem

I have a Zenith SY1324S-01 TV mfd. in May 1997. The vertical deflection is intermittent. Sometimes the picture is fine,...
2 comments posted 20yrs
posted by g_czplzn
2 comments posted 20yrs posted by g_czplzn

Toshiba update

Model #27A33. I didn't have this # last night. Anyhow, I managed to inject a horizontal drive signal this time at the b...
0 comments posted 20yrs
posted by stokesb
0 comments posted 20yrs posted by stokesb

Vivitar 285 flash schematic/info wanted

Hey all. I just recently ebay'd up a Vivitar 285 flash to work with my Pentax *ist-DS DSLR. I measured the trigger volta...
0 comments posted 20yrs
posted by papenfussDIESPAM
0 comments posted 20yrs posted by papenfussDIESPAM