Tom MacIntyre wrote in news: snipped-for-privacy@4ax.com:
main
I believe you.
When theory and reality clash, it is better to believe reality. This TV has audio.
board.
-- bz 73 de N5BZ k please pardon my infinite ignorance, the set-of-things-I-do-not-know is an infinite set. bz+ser@ch100-5.chem.lsu.edu remove ch100-5 to avoid spam trap
The G1 short probably won't show up with an ohm meter check. The G1 short probably won't show up until the gun assembly is heated up and the internal structures warp into position that will cause the short. If you want to check for shorts on the G1, apply 6.3v to the filament, then check with the ohm meter.
" snipped-for-privacy@locl.net" wrote in news: snipped-for-privacy@g47g2000cwa.googlegroups.com:
If the problem were the G1 short and the cathode had to be hot first, then I would expect there to be some HV appear on the faceplate when the power is first applied, before the fuse blows.
There is no 'crackle' nor hair on arm standing up [when held near faceplate] when I replace the fuse and turn on the power.
-- bz please pardon my infinite ignorance, the set-of-things-I-do-not-know is an infinite set. bz+sp@ch100-5.chem.lsu.edu remove ch100-5 to avoid spam trap
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.