1. Home
  2. Electronics Repair
  3. Zenith no sound

Zenith no sound

I have a Zenith model #SJ1325W. Repaired the vertical deflection problem, but no sound. I traced the audio with a scope from the processor to the audio amp and no audio. I figured bad processor, so replaced it and the audio amp for good measure. Still no audio. Substituted coupling caps also but no luck. The set keeps showing mute OSD when channels are changed. Hit mute on remote, but still no audio. The word mute and the volume bar stay the color red also, not sure if it should go green when not muted. Is something gimped in the set up possibly? If so, would any of you have the access code to fix? I don't know what else could be wrong. Thanks for the replies.

Reply to
stokesb
Loading thread data ...

I guess I'll reply to myself, I found 2 pins that were bent over on the bottom of the PCB that may have been shorting to another circuit. I now have sound, but I can't replicate the no sound problem shorting the same pins. As much as I hate too, I have to let this one go as repaired. Next time, I will take the time to get a schematic to see exactly what's going on. See yall. P.S. A little dissapointed I didn't get one response though. Figure I tried everything that anyone would have suggested?

Reply to
stokesb

Replies sometimes take a day or two... Hope it works Ok for you. Time will tell

Reply to
kip

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.