M # KV-27TS27, was dead, replaced Q502: 2SC4927 H.O.T., Q601, 602 2SC4664 regulators, R647 ohm fusible resistor, C613 .047 uf @ 400 volts, 2.5 amp gma fuse, & D 622 is ok! Worked perfect for about 30 seconds, then po go the parts! Flyback common to go? Ideas? Rono.
Sony 27" T.V.!!
Jun 18, 2005
3 Replies
Dry joints on Drive Trany plus other dry joints on Hor drive Txr..
You know i did that! Looking for something I missed!.........Anyone????? Rono.
Rono: You certainly did NOT mention that you checked for dry joints on the HDr xstr and xfmr.... it was a good suggestion to your request. ALSO.... did you check the black and green varistors? .... the small "chicklet" caps? And when you think that you have caught everything you should bring it up real slow on a variac while watching the SMPS transformer waveforms on your oscilloscope..... lots of good repair suggestions can be found per the Sony factory service literature and numerous postings on this newsgroup..... do an archives search on google groups for lots of case histories and specific information.... a good place to learn from other's experiences, and don't forget to contact SONY and obtain their service suggestions for this. electricitym . .
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required