Sanyo Model Ds25330

When power is applied no video or audio and after about 5 seconds you can hear the power relay trip off. Should I start by checking the power supply diodes? Thanks for any help!

The master needs to know what kind of power supply this unit has... Switch mode... STR Reg... etc...?

Can you scope the HOT collector as the set starts and verify good B+ and a clean pulse?

========================== Jeff Stielau Shoreline Electronics Repair

Also check the 200 volt line to the video driver transistors at the CRT board.

Mark Z.

That model was famous for shorted yokes. If the horizontal output is shorted, save yourself some time and loosen the yoke and carefully slide it off the neck of the picture tube and look at the coils. If you see even a small black, charred area, it's shorted and any parts you change on the pcb is a waste of money. I have used the yokes off 25" Magnavox's that only required cutting and splicing the yoke connector and worked perfectly.