the VCR module (of the combo is CXB1922/CX. Had a tape jammed, I was able to remove it (w/o breaking anything) now the rollers, etc all go back and forth pretending as if there were a tape loaded and it was playing it. As such, it sends a PLAY signal to the TV on screed display, which must be stopped manually. But it keeps cycling, with its phantom tape it keeps trying to play.
All the caps look intact. Any thoughts?
Thanks for your input. T
"All the caps look intact. Any thoughts?" Yea...... take it to a repair shop so a TECH can provide you with a proper repair or at the very least a repair cost estimate so you can make an intelligent repair decision with facts instead of wild guesses. ...... BTW, my wild guess would be faulty gear timing, dirty mode switch, faulty BOT or EOT sensors, faulty IR Emitter, etc, etc, ...... notice that none of these wild guesses even came close to mentioning faulty caps.
(TECH = person who knows what to look for and has the abilty to actually TEST components with test equipment.... i.e. parts that look "intact" can actually be quite faulty) electricitym
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.