Hi, my Panasonic Quintrix F 24" TV keeps stretching the display in the horizontal direction (objects became fatter). I was told that re-solder FBT section may solve the problem. I can reach the solder side without disconnecting the anode from the tube. My concern is should I discharge the anode & AC input filter capacitor before proceeding?
Thanks in advance ck
You don't need to discharge the CRT before soldering the FBT.
--- sam | Sci.Electronics.Repair FAQ:
Important: Anything sent to the email address in the message header above is ignored unless my full name AND either lasers or electronics is included in the subject line. Or, you can contact me via the Feedback Form in the FAQs.
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.