How about the possibility of a S/C triac/welded relay contacts?
How about the possibility of a S/C triac/welded relay contacts?
Peter Ashby inscribed thus:
Hi Peter,
Yes it was very definitely light falling on the LED. I encased the noise source and amplifier in a tin box and that cured it permanently. The whole thing ran from a 9 volt battery, so there couldn't be any PSU noise.
-- Best Regards: Baron.
bz inscribed thus:
You are right ! Actually it was a tin box, but same result !
-- Best Regards: Baron.
Martin Pentreath schrieb:
You could use any digital camera with a CCD sensor to look at the IR LED. The cam CCD picks up IR light and shows it as white light on the cam screen. Try it on your TV remote while pushing one of its buttons.
Then you can check if your shredder's IR LED is working.
Every time I've had the issue; it was the emitter/sensor that failed; NOT the downstream triac/relay...
-- A host is a host from coast to coast.................wb8foz@nrk.com & no one will talk to a host that's close........[v].(301) 56-LINUX Unless the host (that isn't close).........................pob 1433 is busy, hung or dead....................................20915-1433
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.