Hi.
My english is not verry good so i hope you understand me.
I have one Infocus LP250 that wont start. Is ther anyone out ther that have any clue what it can be? It seams to be a quit usual problem on this model? I think the problem is in the power unit but im not sure.
Best Regards Tobias
Does the standby indicator glow? The chameleon power l.e.d. reports the state of the unit.
"solid green: The projector is plugged in, or the projector has been turned on and the software has initialized. The projector has been turned off and the fans have stopped.
blinking green: The Power button has been pressed and the software is initializing, or the projector is powering down and the fans are running to cool the lamp.
blinking red: A fan or lamp failure has occurred. Make sure the vents aren't blocked. Turn off the projector and wait one minute, then turn the projector on again. If the projector has been working for 2000 hours or more, replace the lamp and reset the lamp timer by pressing Volume +, then Volume -.
solid red: An unidentifiable error: please contact Technical Support."
Which of the above four modes does the l.e.d. report? Jango
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.