Hello,
There is an undocumented method for aligning the 3 lcds in this Epson/ Sieko optical engine used in this InFocus model LP730 video projector. I have magenta borders to one side. If I could slide that LCD over about 10 pixels, everything would be OK.
I've looked at the asssembly and maybe it could be done manually but it is a bear. I understand there is an electronic method but it requires codes and/or jumpers. The manufacturer no longer services this model.
Any thoughts?
Thnaks!
Going back a good number of years, I used to service an Infocus projector. I cannot remember the model. The convergence was mechanical on the one that I used to work on. It was a very difficult task to get a good convergence out of it. In its time it was okay, but it would never meet the specs of one of today! We had to get rid of it because we were no longer able to have parts or support for it.
For a reasonable cost, you can get a very nice modern projector that is supported, and it will be superior to the Infocus unit. We use to call it an "Outfocus", because of all the problems we had with it!
-- JANA _____ "TMI" wrote in message news:1191554323.038989.184330@g4g2000hsf.googlegroups.com... Hello, There is an undocumented method for aligning the 3 lcds in this Epson/ Sieko optical engine used in this InFocus model LP730 video projector. I have magenta borders to one side. If I could slide that LCD over about 10 pixels, everything would be OK. I've looked at the asssembly and maybe it could be done manually but it is a bear. I understand there is an electronic method but it requires codes and/or jumpers. The manufacturer no longer services this model. Any thoughts? Thnaks!
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.