Apparently my A650 got moisture-damaged so the PC board needs to be replaced.
How hard is it to do this? Any give me instructions?
Thanks
Apparently my A650 got moisture-damaged so the PC board needs to be replaced.
How hard is it to do this? Any give me instructions?
Thanks
It should just fall off. It's held in place by 3 plastic "latch" tabs that hold the back cover. When the back cover is removed, the top cover should pivot on some tabs in front and just fall off. There are no screws holding it in place.
-- Jeff Liebermann jeffl@cruzio.com 150 Felker St #D http://www.LearnByDestroying.com Santa Cruz CA 95060 http://802.11junk.com Skype: JeffLiebermann AE6KS 831-336-2558
Thanks for your response Jeff, but nothing is falling off! :-)
So the 3 plastic latch tabs that were holding the back cover are part of the front cover, not part of the chassis? The top edge of the front cover is very tight and cannot be persuaded off, even though we have the bottom loose.
Is the curved part on the front that covers the batteries (below the zoom control) part of the front parnel, or is separate? Can't get either one loose, separately or together. If separate, which comes off first?
By the way, none of the buttons on the back panel are working. Also the zoom control does not work, the camera automatically goes to 24X zoom when turned on. The shutter usually does not work.
Any ideas? I assume the electronic module behind the back push buttons is screwed, but would that mess up the zoom too? Anyway to test this module? It looks fine, not corrosion, no apparent water damage.
Thx.
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.