Do you have a question? Post it now! No Registration Necessary
posted on November 17, 2004, 1:30 am
Reply
Save
Print
I'm designing an embedded linux setup that will be powered on and off
sporadically without any means of a careful, controlled shutdown. I'm
looking for some ideas?
My plan is to use a ramdisk, read only partition and a data write
partition. I was planning on going with Linux 2.6 and wanted to use
Reiser 4 as the filesystem. Everything will be located on a DOC.
Can anyone suggest a better setup? Maybe I'm overlooking something.
Cheers,
Willem
sporadically without any means of a careful, controlled shutdown. I'm
looking for some ideas?
My plan is to use a ramdisk, read only partition and a data write
partition. I was planning on going with Linux 2.6 and wanted to use
Reiser 4 as the filesystem. Everything will be located on a DOC.
Can anyone suggest a better setup? Maybe I'm overlooking something.
Cheers,
Willem
Site Timeline
- » PCMCIA modem fails when sending AT commands without delays
- — Next thread in » Embedded Linux
-
- » ifconfig hang on Arcturus uCdimm
- — Previous thread in » Embedded Linux
-
- » Crosscompiling for ARM: reloc type R_ARM_ABS32 is not supported for PIC - ...
- — Newest thread in » Embedded Linux
-
- » Quanta corrente potrà fornire?
- — The site's Newest Thread. Posted in » Electronics Hobby (Italian)
-
- » CR1616 en remplacement de CTL1616
- — The site's Last Updated Thread. Posted in » Electronics (French)
-
XML Sitemap