1. Home
  2. General Electronics
  3. Optrex DMF50073N LCD

Optrex DMF50073N LCD

Hi, I've just been given an Optrex DMF50073N/F-FW LCD panel. Unfortunately, the only data I've got is a rather bad copy of the pinout. Does anyone have a copy of the datasheet? All I really need are the timing specs and a timing diagram.

Thanks.

-- Phil. | Acorn RiscPC600 Mk3, SA202, 64MB, 6GB, snipped-for-privacy@despammed.com (valid address)| ViewFinder, 10BaseT Ethernet, 2-slice,

formatting link
| 48xCD, ARCINv6c IDE, SCSI No to DRM, software patents and the EUCD! ... I can't think of anything witty to say right now.

Reply to
Philip Pemberton
Loading thread data ...

If it's a character display, it's probably controlled by an HD44780 chipset. Google HD44780 and you will find the necessary timing.

BRW

Reply to
Bennet Williams

It's a graphics display - low-level control only. It doesn't have a command-based controller onboard (e.g. SED1550). Instead, it's got a bunch of row and column driver ICs.

Later.

--
Phil.                                | Acorn RiscPC600 Mk3, SA202, 64MB, 6GB,
philpem@despammed.com (valid address)| ViewFinder, 10BaseT Ethernet, 2-slice,
http://www.philpem.dsl.pipex.com/    | 48xCD, ARCINv6c IDE, SCSI
No to DRM, software patents and the EUCD!  
... Laugh ?  I nearly paid the poll-tax
Reply to
Philip Pemberton

I found one of them on an old photocopier. On the main board where it is connected, I have found a SED1330F with 2 mem chips(GM76C256). Near is a quartz of 9.216Mhz Perhaps it can help. NB: the connector is a 14 pins

Reply to
papat44

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.