Field-Programmable Gate Arrays

15255 Threads Posts
to

BF957C Application

Can someone suggest a project/application that would call for an XC2V6000-4BF957C? Thanks. -Emile
4 comments posted 23yrs
posted by banktrade2002
4 comments posted 23yrs posted by banktrade2002

More RPM / RLOC fun

So...I have this little module that creates an RLOC'd SRL-based delay pipe that will feed one side of an adder in an FI...
19 comments posted 23yrs
posted by 0_0_0_0_
19 comments posted 23yrs posted by 0_0_0_0_

Installing Xilinx 6.1 under Linux

Hi, I've got Suse 8.1 on my machine and I'm trying to install Xilinx 6.1 sw. Admittedly they recommend RedHat, but I ca...
6 comments posted 23yrs
posted by arthur
6 comments posted 23yrs posted by arthur

ise 5.2 sp 3 for spartan 3

Hi I have a design which takes about 74% resources on a sparta 3 1.5 m device. I am compiling on 5.2 sp3. The routing f...
1 comments posted 23yrs
posted by anjanr
1 comments posted 23yrs posted by anjanr

RLOC specification

How do I specify the use of the F or G LUT in a slice? Can I? Does it matter? Why? How do you reduce wasted resources i...
2 comments posted 23yrs
posted by 0_0_0_0_
2 comments posted 23yrs posted by 0_0_0_0_

SDRAM types and availability

I was discussing SDRAM a few weeks ago and I can't seem to find it in this newsgroup. I guess it had gone to email. I h...
2 comments posted 23yrs
posted by spamgoeshere4
2 comments posted 23yrs posted by spamgoeshere4

Design question (Working with Altera EPXA1F484C1)

I have a question about how I best should implement my I/O in an FPGA (Altera EPXA1F484C1) . Being a student, and not h...
1 comments posted 23yrs
posted by panic74
1 comments posted 23yrs posted by panic74

Problem with PCI cards

I have developed the PCI-device for which it is necessary 128 bytes of ports of input-output, 512 Kb of memory and one...
10 comments posted 23yrs
posted by irum4
10 comments posted 23yrs posted by irum4

synplify vqm not able to fit in Quartus

Hi, I am trying to fit this particular design. I run Synplify Pro to map the device. In Synplify, with mapping logic to...
7 comments posted 23yrs
posted by stenasc
7 comments posted 23yrs posted by stenasc

Should I worry about metastability

Hi, I need to synchronize an incoming 27MHz signal (50% duty cycle) with an internal clock running at 108Mhz (which is...
31 comments posted 23yrs
posted by geschemann
31 comments posted 23yrs posted by geschemann

Timing from 1x to 2x and back

My collegue and I discussed how our placer (xilinx's) handled going from 1x clocks to 2x clocks and back. (These have o...
5 comments posted 23yrs
posted by m-leik
5 comments posted 23yrs posted by m-leik