Field-Programmable Gate Arrays

15255 Threads Posts
to

a pci implemenation problem, thanks

I design a simple pci target, with only config read/write, NOT response to normal read/write operation, but I implement...
4 comments posted 22yrs
posted by nothisrat
4 comments posted 22yrs posted by nothisrat

What was the first FPGA?

This probably ought to be in the FAQ... then again perhaps there isn't a clear answer to this, since the definition of "...
4 comments posted 22yrs
posted by adam
4 comments posted 22yrs posted by adam

ModelSim

Where are there some really easy point and click tutorials for ModelSIM?
9 comments posted 22yrs
posted by bradsmallridge
9 comments posted 22yrs posted by bradsmallridge

BCD to bin convertor

Hi everybody, I'am searching for 4 digits BCD (=16 bits) to BIN convertor. If possible in VHDL. Thanks
6 comments posted 22yrs
posted by jpr
6 comments posted 22yrs posted by jpr

How many Altera LE's to Xilinx Slices????

Hello All, I've been designing with Xilinx FPGAs for a while so I'm used to the "Slice" concept. I'm looking at Altera'...
15 comments posted 22yrs
posted by ericjohnholland
15 comments posted 22yrs posted by ericjohnholland

XAPP253

I am trying to understand XAPP253, a DDR SRAM controller. Is the use of a RAM LUT still a good idea for transferring da...
0 comments posted 22yrs
posted by bradsmallridge
0 comments posted 22yrs posted by bradsmallridge

which xilinx CPLD to select?

I am pretty new to the Xilinx world and I am seeking the answers to my questions here. The requirements are listed here...
14 comments posted 22yrs
posted by vax9000
14 comments posted 22yrs posted by vax9000

Quartus 4.0, Excalibur Synthesis problem

Hi, I am facing a strange problem while doing Synthesis P&R of a logic on "Excalibur" device (Altera EPXA10F1020C1 Pack...
0 comments posted 22yrs
posted by viveklk
0 comments posted 22yrs posted by viveklk

ISE 6.2 EDF mapping problem

I started a new project with an EDF file (generated from synplicit pro), when i then translate, map and read the log fi...
0 comments posted 22yrs
posted by trican.1e5z5a
0 comments posted 22yrs posted by trican.1e5z5a

Question on Xilinx VirtexPro II FPGA chip... please

I'd appreciate if someone could answer a few questions below: If you reply by email, REMOVE "SPAMNOMORE" in capital let...
5 comments posted 22yrs
posted by MetalBladeSPAMNOMORE
5 comments posted 22yrs posted by MetalBladeSPAMNOMORE

WebPACK post-PAR min clock period?

I'm using WebPACK 6.3.01i. The synthesis report tells me the minimum clock period is about 17 ns. How do I get the same...
10 comments posted 22yrs
posted by eric-no-spam-for-me
10 comments posted 22yrs posted by eric-no-spam-for-me