Field-Programmable Gate Arrays

15255 Threads Posts
to

Xilinx OPB custom interface

I created a custom opb component using the create peripheral wizard. Im using the IP2BUSxferAck to provide a 4 wait sta...
2 comments posted 21yrs
posted by rklosinski
2 comments posted 21yrs posted by rklosinski

JOP on Trenz Retrocomputiong Board

Trenz Electronic provides a nice, very small Spartan-3 module and a carrier board with all the stuff to build a complet...
0 comments posted 21yrs
posted by martin.schoeberl
0 comments posted 21yrs posted by martin.schoeberl

Low cost million gate Spartan 3 board?

I have seen a few low cost($100-$200) fpga boards with 400k Spartan 3's, but nothing with 1million gates yet. I would t...
7 comments posted 21yrs
posted by javaguy11111
7 comments posted 21yrs posted by javaguy11111

Modelsim library problem

Hello Im using Modelsim XE 5.5e for simulation. All was going well until I attempted to include delay information in my...
1 comments posted 21yrs
posted by dgleeson-2
1 comments posted 21yrs posted by dgleeson-2

VLSI professional at NASA

Hi, How to be part of NASA as a VLSI Design engineer? Regards, Muthu
4 comments posted 21yrs
posted by muthusnv
4 comments posted 21yrs posted by muthusnv

Spartan 3 output voltage level

I would like to integrate an 8051 microcontroller to a spartan 3 development board. For input port I know I need to add...
13 comments posted 21yrs
posted by lkiss80
13 comments posted 21yrs posted by lkiss80

Xilinx EDK Simulation - Unresolved references

Hello I am trying to simulate verilog behavioural model of my PPC based design using Xilinx EDK and Modelsim 5.7G SE PL...
0 comments posted 21yrs
posted by swamydp
0 comments posted 21yrs posted by swamydp

Altera chip identification

hello all, it is not a question concerning FPGA but I could get the answer here: from old devices that went to trash I...
4 comments posted 21yrs
posted by moi
4 comments posted 21yrs posted by moi

18x18 Multipliers - Spartan III

I am doing some test with the Spartan III multipliers. I have tried the following simple code: entity mac_ex is generic...
11 comments posted 21yrs
posted by cas7406
11 comments posted 21yrs posted by cas7406

FPGA development board

Hi all, I'm new to FPGA and CPLD. Had just started learning VHDL, I'm keen to implement my design on real Xilinx FPGA....
9 comments posted 21yrs
posted by nospam4u_jack
9 comments posted 21yrs posted by nospam4u_jack

5V PCI interface using Spartan3

Hello All, Is it possible to use spartan3 for 5V PCI interface? I seems that there is no problem to use for 3.3V PCI int...
2 comments posted 21yrs
posted by helloone
2 comments posted 21yrs posted by helloone